After 2 years of getting outstanding results with Suite Pro controls, I am having a very hard time moving my development to v15.2.1 on a different PC and would greatly appreciate any assistance you all can offer. I have been developing on a 64-bit Win 7 PC running Suite Pro 13.2. Since I cannot get any release I build with it to successfully run on a 32-bit PC after ensuring all target platforms are x86 (I will try to figure that out later unless somebody has fool-proof instructions for troubleshooting it), I would like to move development back to my old 32-bit Win 7 laptop that always produced builds that appeared to install properly everywhere.

I recently installed Suite Pro 15.2.1 on that original laptop, ran the registrator to use Unicode, and built some quick test projects that worked fine. However, when I open the source code copied from my 64-bit PC, I receive over 100 errors that indicate:

Type ‘AxXtremeSuiteControls.AxXXXXX’ is not defined.

I am hoping somebody can provide a set of clear steps I can follow to get my source code to recognize the Suite Pro 15 controls so I can again build releases that install properly on all PCs. I should mention that this is the first time I installed the Unicode versions. Up to now I’ve been using the ANSI controls, but I intend to start localizing my software in different languages.

Thank you very much.