![]() |
Combo is disabled in Compiled Mode |
Post Reply ![]() |
Author | |
Bjarne ![]() Newbie ![]() ![]() Joined: 30 December 2003 Location: Denmark Status: Offline Points: 28 |
![]() ![]() ![]() ![]() ![]() Posted: 16 May 2004 at 3:57am |
Hello, I discovered something strange. On a Toolbar I add two Combo boxes by code, I fill them with a couple of values and thats it. When I run the project from VB IDE everythings works fine. But if I compile the project and run it, I can still click on the drop down arrow to the right but all values are greyed out and can not be selected. There is nowhere in my code that I disable any controls, so I am really puzzled. Any ideas? Bjarne |
|
![]() |
|
SuperMario ![]() Admin Group ![]() ![]() Joined: 14 February 2004 Status: Offline Points: 18057 |
![]() ![]() ![]() ![]() ![]() |
Did you ever find a solution to this?
|
|
![]() |
|
gallman ![]() Newbie ![]() Joined: 06 September 2004 Status: Offline Points: 18 |
![]() ![]() ![]() ![]() ![]() |
I'm experiencing this problem too using v9.1 ActiveX with VB6 SP6.
|
|
![]() |
|
SuperMario ![]() Admin Group ![]() ![]() Joined: 14 February 2004 Status: Offline Points: 18057 |
![]() ![]() ![]() ![]() ![]() |
OK, this was a problem and is fixed in the next version.
![]() |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |